久久夜色精品国产嚕嚕亚洲av_欧美日韩国产一区二区三区不卡_鸭子tv国产在线永久播放_久久天天躁狠狠躁夜夜不卡_日本特黄特色aaa大片免费

Welcome toZhejiang Yuman Electric Technology Co., Ltd.Official website, we focus on the production and sales of high-quality fans!

Tel:86-15068298836 / 13868374889

Home / News / Commonly problematic parts of stainless steel fans

Commonly problematic parts of stainless steel fans

date:[2021-02-24]     pk_hits:

The stainless steel fan is simply a kind of equipment for conveying gas, and its composition is not complicated. Stainless steel fan installation preparation


The main parts of a stainless steel fan are: impeller, volute, air inlet, bracket, motor, pulley, coupling, muffler, transmission (bearing), etc.


After the stainless steel fan is used for a long time, some parts will have problems under the influence of external factors or its own material factors.


Today, I will introduce to you which parts often have problems.


1. Gear


When designing the gear of the stainless steel fan, a certain amount of tooth wear is calculated. During normal use, its wear is negligible.


If the oil level in the gear box is high, it will cause too much oil to heat up during agitation, and the temperature at the bottom of the oil tank will be too high.


If you continue to operate in this situation, the gear will heat up and the gear may be affected by rapid wear, which will cause the impeller blades to contact or the unit to jam.


2. Bearing


The service life of the booster is closely related to the bearing.


Gradual wear may change the position of the shaft until friction occurs between the impeller and the cylinder block or top plate, and sudden bearing failure usually has serious consequences.


Because the impeller shaft assembly is no longer supported and correctly positioned, extensive damage to the casing and gear may occur immediately after the bearing fails.


3. Transmission shaft sealing components


The assembly is composed of two independent lip seals immersed in oil and located in the drive end cover.


If the oil level of the oil gauge rises, it means that the oil leakage through the inner member is excessive, and it should be replaced as an assembly.


Unless the seal or its bearing surface is damaged, the possibility of leakage through the outer member is unlikely.


In addition, the smoothness of the shaft also has a considerable influence on the performance of this type of seal. The operation problem may be caused by reasons other than component damage.


Since the gap is only a few thousandths of an inch, installation changes or pipe support changes may cause interference and friction.


Four, casing


Foreign matter entering the stainless steel fan casing can also cause some trouble.


If you encounter this type of problem, but you find that the inside of the casing is clean, please disconnect the pipe and loosen the mounting bolts, and re-level and align the driver.


After tightening the installation, make sure that all pipes are properly connected to the unit before reconnecting.


The above is the introduction about the problems with stainless steel fan parts. You must check and maintain it regularly during actual use.


Focus on the production of electrical equipment series products

Contact Us

If you have any questions, suggestions and products you want to know, you can contact us at any time. Looking forward to your consultation?

message

公侵犯玩弄熟睡人妻电影| 玩弄丰满奶水的女邻居| 亚洲日韩欧美一区二区三区| av诱惑一区二区三区| 亚洲啪av永久无码精品放毛片| 国产成人精品a视频| 极品少妇xxxx精品少妇偷拍| 国产乱人伦偷精品视频下| 精品国产成人一区二区| 军人粗大的内捧猛烈进出视频| 精品一区二区三区在线视频| 国产成人露脸自拍视频| 每日更新在线观看av| 国产成年女人毛片80s网站| 亚洲最大激情中文字幕| 少妇人妻陈艳和黑人教练| 国产av无码专区亚洲avjulia| 精品亚洲aⅴ在线观看| 18禁裸乳无遮挡啪啪无码免费| 日韩精品久久久中文字幕| 五月丁香综合缴情六月小说| 18禁免费无码无遮挡不卡网站| 亚洲精品国产专区无套| 亚洲av片无码久久五月| 国产精品无打码在线播放| 公粗挺进了我的密道在线播放贝壳| 一本色综合亚洲精品蜜桃冫| 亚洲综合av一区二区三区| 日本一卡二卡不卡视频查询| 亚洲人成电影免费观看在线看 | 久久国产亚洲欧美久久| 四虎库影成人在线播放| 风韵少妇性饥渴推油按摩视频 | 小13箩利洗澡无码免费视频 | 女人让男人桶爽30分钟| 国产亚洲精品无码专区| 国内精品久久久久久久小说| 性欧美俄罗斯极品| 人妻在卧室被老板疯狂进入国产 | 亚洲国产欧美日韩精品一区二区三区| 日本一卡2卡3卡四卡精品网站|